Normal uterus and FIGO stage I endometrial carcinoma: dynamic gadolinium-enhanced MR imaging

Dynamic magnetic resonance (MR) imaging was performed on a 1.5-T superconducting unit for evaluation of 26 stage I endometrial carcinomas. To establish the appearance of the normal uterus, 27 normal uteri were also evaluated. After rapid injection of gadopentetate dimeglumine, dynamic images were obtained every 30 seconds with the spin-echo technique in the sagittal plane. On dynamic studies of endometrial carcinoma, the tumor-myometrial contrast was marked at 120 seconds after administration of gadopentetate dimeglumine (contrast-to-noise ratio [C/N], 26.0). The tumor-myometrial contrast on the dynamic study was more marked than that on postcontrast T1-weighted images (C/N, 10.0) and on T2-weighted images (C/N, 2.14). Dynamic and postcontrast MR images were superior in enabling differentiation of viable tumors from necrosis or residual secretion in the endometrial cavity. In the evaluation of presence of tumor and myometrial invasion, the accuracy of T2-weighted imaging and dynamic imaging was 67.9% and 84.9%, respectively.     

A 10 bit 20 MS/s 3 V supply CMOS A/D converter

A 10 bit CMOS A/D converter with 3 V power supply has been developed for being integrated into system VLSI's. In this A/D converter, redundant binary encoders named “twin encoders” enhance tolerance to substrate noise, together with employing differential amplifiers in comparators. The bias circuit using a replica of the amplifier is developed for biasing differential comparators with 3 V power supply. Subranging architecture along with a multilevel tree decoding structure improves dynamic performance of the ADC at 3 V power supply. The A/D converter is fabricated in double-polysilicon, double-metal, 0.8 μm CMOS technology. The experimental results show that the ADC operates at 20 MS/s and the twin encoders suppress the influence of substrate noise effectively. This ADC has a single power supply of 3 V, and dissipates 135 mW at 20 MS/s operation     

Frequency response function of magnetic bearings using high-temperature superconductor

A high-temperature superconductor YBa₂Cu₃O_7-x with strong pinning force has allowed stable magnetic suspension with no control to be developed. Two types of superconducting magnetic bearings (SMB) using YBCO and permanent magnet were assembled. The two types are radial and axial. The dynamic stiffness of each SMB as it was cooled down under a magnetic field by liquid nitrogen was measured both radially and axially. As a result, it was found that the spring constants of these SMBs were almost as large as a practically desirable value; however, their damping coefficients were lower than the practical level. These findings are useful as one of the data bases for development of an optimum SMB design to support the weight of rotors in an axial direction.     

Modal dispersion control and distortion suppression of picosecondpulses in suspended coplanar waveguides

The propagation and dispersion characteristics of picosecond electrical pulses in a suspended coplanar waveguide (SCPW) are investigated, and it is shown that the SCPW is a very promising transmission structure for ultrashort pulses. Numerical results for the modal dispersion of the SCPW are presented and compared to those of the conventional CPW, and a field-coupling theory is used to explain the evolution in the dispersion behavior. An evaluation based on the numerical analysis shows that a SCPW with properly controlled dispersion can exhibit a five times improvement in pulse transmission capability compared to the conventional CPW. Both computer simulations and experimental measurements show a substantial suppression in pulse distortion as well, compared to conventional CPWs     

A shell for signal interpretation expert systems

System monitoring and diagnosis through signal interpretation are important tasks in many engineering fields. Although monitoring or diagnosis expert systems help human experts a lot, it is not so easy to build a signal interpretation expert system. We have developed two expert systems for speech signal processing. The close analysis of the two systems revealed common functions and modules applicable to wide range of signal interpretation problems. On the basis of the experience, we have developed a shell for signal interpretation expert systems named SSI. In order to evaluate SSI, we also developed two expert systems by using it and obtained satisfactory results. This paper describes the design philosophy and architecture of SSI together with some examples.     

Radiation tolerance of type IIa synthetic diamond detector for 14 MeV neutrons

Radiation tolerance of a type IIa synthetic diamond detector was examined from irradiation of mono-energetic 14 MeV neutrons. Measurements of I–V (current–voltage) characteristics and energy spectrum for 5.486 MeV alpha particles were performed after neutron irradiation. In the I–V characteristics measurement, enhancement of rectification was observed after neutron irradiation of up to 2.0 × 10¹² n/cm². Concurrently with the enhancement of rectification, significant decrease in signal amplitude was observed in energy spectrum measurement for alpha particles. It is considered that these changes were due to increase in the concentration of defects acting as shallow energy levels in the forbidden band. For neutron irradiation of higher than 1.6 × 10¹³ n/cm², weakening of the rectification characteristics and recovery of the signal amplitude were observed. These changes imply that deep energy levels, which were also considered to be introduced by defects, were dominant and weakened the effects of the shallow energy levels. Increase in the concentration of the deep trapping levels resulted in gradual decrease of the signal amplitude and degradation in the energy resolution. The peak for the alpha particles was obtained up to 5.5 × 10¹³ n/cm².     

Multiobjective dynamic load-dispatching method for optimal operation of power systems

A new practical method is proposed which gives a quasi-optimal solution of the dynamic load-dispatching problem formulated by a multiconstraint multiobjective optimization problem. Here, the multiple constraints are rate reserve constraints and power flow ones, and the multiple objectives are fuel cost and CO₂ emission. The proposed method is an integration of the following three techniques: (1) “Group Dispatch Scheme,” which is developed by the authors, is used to satisfy a violated constraint easily. This scheme consists of three steps. The first step is to classify all generators into two groups. One is the group which should be more loaded to satisfy the violated constraint, and the other is the should-be less loaded group. The second step is to add some load to the former group, and to subtract the same load from the latter. The third step is to dispatch each group load to each groups generators, respectively; (2) the dynamic load-dispatching algorithm is used which provides, in practical time, quasi-optimal generation trajectories; (3) the conventional weighting parametric method is used to obtain a Pareto optimal solution of multiobjective problems. The effectiveness of the method is clarified by a computer simulation on the actual power system of Kansai Electric Power Company.     

The monoamine regulon including syntheses of arylsulfatase and monoamine oxidase in bacteria

Bacterial cells respond to monoamine compounds, such as tyramine, dopamine, octopamine, or norepinephrine, and induce the syntheses of tyramine oxidase encoded by tynA and monoamine oxidase encoded by maoA. These monoamine compounds also derepress the synthesis of atsA-specified arylsulfatase that is repressed by sulfur compounds. These complex mechanisms of regulons regulated by monoamine and sulfur compounds has been analyzed by cloning and characterization of genes that are involved in the repression and derepression of the synthesis of arylsulfatase. The atsA gene forms an operon with the atsB gene, which encodes an activator of the expression of atsA. The negative regulator gene for arylsulfatase was found to code for dihydrofolate reductase (folA). The maoA gene forms an operon with the maoC gene, which has similarity to a dehydrogenase involved in the tyramine metabolism. The moaF gene encoding a 30-kDa protein, which is induced by tyramine, also forms an operon with the moaE gene. Finally, the moaR gene, which is induced by monoamine, was found to play a central role in the positive regulation of the expression of the monoamine regulon (moa) including the atsBA, maoCA, moaEF, and tyn operons. The moaR expression is subject to autogenous regulation and to cAMP-CRP control. The MoaR protein has a helix-turn-helix motif in its C terminus. Thus, the MoaR protein probably regulates the operons by binding to the regulatory region of the moa regulon.